DrJarmin

Expectations Affiliate

Sorry, I am sure this ought to be apparent, but I can’t find it out – probably after examining the handbook!

Best ways to link your Yamaha RX3900 radio to a Velodyne CHT-Q sets subwoofer.

The sub provides stereo (l+r) stimulant (all We have purchased before have seen mono stimulant) and so the yamaha amp hasn’t got a subwoofer result exactly where all of those other speaker system components are situated.

Bless you, and be sure to ignore my own stupidity – i know the answer is going to be obvious once I realize.

IronGiant

Moderator

You intend to hook up the Pre-OUT Subwoofer from the Yamaha to either the left or suitable station on the Velodyne

It is just on top of the mid from the three orange electronic coaxial inputs regarding the Yamaha

Revise: apologies that you’s an enter, usually the one you desire is definitely a number of even more on the right whenever properly determined it.

DrJarmin

Requirements Manhood

Okay, thankfulness. It has been the left and right which was baffling me personally.

Why does the sub have left and suitable channels?

IronGiant

Moderator

If for example the amplifier doesn’t always have a devoted submarine woofer channel ie try HiFi perhaps not an AV recipient, but have stereo pre-outs, you may deliver the entire array right and left route to your submarine towards submarine to extract the LFE wavelengths from.

Since you have the LFE as a mono sign you won’t need to get connected to both, although some everyone accomplish utilizing a phono splitter. Most subs get one and other of the Left and Right in addition marked upward as mono, or perhaps you may find the sub handbook advocate one during the more.

DrJarmin

Traditional Member

Ah, ok, I do think I have they.

Discover a whole lot to find out about this theme.

Thank you for your allow.

DrJarmin

Standards Representative

One final matter, seems like i want a wire with a male connector at one end (to plug in the Yamaha) and a simple line on the other (to hook up to either the left or appropriate input from the back of the subwoofer).

I’ve a couple of AV leads with fittings on, does one only reduce one close switched off and make use of that? They aren’t specifically heavier measure wire, about the sort of cable you have access to in a Maplins or Dixons. Will that staying enough?

DrJarmin

Traditional Affiliate

I have attemptedto link the subwoofer – nevertheless ain’t performing. Just what was we accomplishing wrong?

I got myself an RCA cable tv and stop one stop. Unsure basically should take advantage of middle line, and the outside wire for remaining or best, but experimented with both.

The sub only offers a continuing hum.

One more stop try plugged into the back of the RX3900 inside the submarine woofer connector, not just the main one on top of the 3 red connectors, but farther along along off to the right in identical row (find out connected).

Accessories

paulst10

Differentiated Affiliate

I got myself an RCA line and blocked one terminate. Undecided if I should take advantage of middle line, and the exterior cable for kept or appropriate, but tried out both.

The sub just has actually a steady hum.

Other terminate is plugged into the back of the RX3900 when you look at the sub woofer connector, perhaps not usually the one higher than the 3 red connectors, but further along to the correct in the same strip (witness attached).

You’ve got the wire connected to the right terminal on Yamaha but you cannot hook a poor level RCA wire to high level audio speaker stimulant, do your very own Velodyne have RCA inputs (low/line degree) ?

Making use of one RCA – RCA cable you just hook from Yamahas sub pre out (the main one you might be using today) to 1 on the the Velodynes low/line stage RCA stimulant

Is it possible to post a photo regarding the rear from the Velodyne or conditions exact unit amount ?